| SUB-SPINDEL ( OPT. ) | GS-200/200L | GS-260/260L | GS-280/280L |
|---|---|---|---|
| Standard turning diameter | Ø 152 mm ( 6" ) | ||
| Max. turning length*¹ | 600 mm / 1,200 mm | ||
| ( 23.62" ) / ( 47.24" ) | |||
| Chuck size*² | Ø 6" | ||
| Hole through spindle | Ø 46 mm ( 1.81" ) | ||
| Spindle bearing diameter | Ø 80 mm ( 3.14" ) | ||
| Hydraulic cylinder | 6" | ||
| Spindle nose | A2-5 | ||
| Spindle motor type | FANUC α112M / 15,000 iB ( AC / Wide-range / cont. Output ) | ||
| Motor output ( cont. ) | 5.5 kW ( 7.5 HP ) | ||
| Motor output ( 30min. / Peak ) | 7.5 kW / 11 kW (10 HP / 15 HP ) | ||
| Motor full output speed | 1,500 RPM | ||
| Spindle drive system | Direct built-in motor ( Integrated Motor ) | ||
| Spindle drive ratio | 1 : 1 | ||
| Spindle speed range | 60 ~ 6,000 RPM | ||
| Spindle full output speed | 1,500 RPM | ||
| Spindle torque ( 30min. ) | 48 Nm ( 36 ft-lb ) | ||
| Spindle torque (Peak) | 55 Nm ( 40 ft-lb ) | ||
| B-axis travel*¹ | + 30 mm, - 570 mm ( + 1.18", - 22.44" ) | ||
| B-axis rapid | 24 m/min. ( 945 IPM ) | ||
| Slide way type | Hardened & Ground Box Ways | ||
| B-axis servo motor | AC 3.0 kW ( 4.1 HP, FANUC α12 / 3,000i, Absolute encoder, 1,000,000/rev. ) | ||
| B-axis ball screw Ø / pitch | Ø 36 mm ( 1.41" ) / Pitch 10 | ||
| B-axis thrust ( cont. ) | 769.4 Kgf (1,692 lb ) | ||
Specifications are subject to change without notice. *1 Individual models may vary, please see interference drawings. *2 Work piece supported by chuck & tailstock. *3 Chucks optional. *4 Optional 10" Big-bore hydraulic cylinder & chuck provide Ø 78 mm ( 3.07" ) bar capacity.
Top